Hair Practice 3

To re-familiarise myself with the design that I have to create, I practiced my design once again on my Katie head to get a plan of how to execute my design in the most time effective way. I am confident with what I have done, and I am sure that when I do this on my model that it will look really effective, I just need to spend a lot of my time getting the partitioning right as this makes the look.

 



Instructions

1. Brush through all the hair to make sure there is no knots or tangles then carefully section it into a middle parting, make sure that this is as straight and as clean as possible.
2. Crimp all of this hair in neat sections all the way up, apart from the top few layers where you only crimp the hair up to the ear.
3. Brush through the crimp to make the hair frizzy.
4. Then take two sections from the front to just behind the ear and section this off on both sides.
5. Then take one of these sections and split it in half horizontally, take the top section and pull this back and drop it, with the front section pull this round the other section and start the waterfall braid, continue braiding until you get to the parting at the back and pin.
6. Do the same as this at the other side of the hair.
7. Take both ends of the waterfall braid and twist them together then plait it all the way down to the bottom.
8. Attach any adornments that have been given to you.
9. Using the pin tail comb backcomb the hair to create volume at the bottom.
10. Run some Hairspray over the top of the hair to get rid of any flyways to make the hair look neat.